Cavity Wall Insulation Extraction by Experts. If your home is effected by Damp or Mold and has cavity wall insulation then you may need it to be extracted. Remedial work should be carried out by professionals with the necessary expertise in this very specialist area of building repairs. CALL US TODAY TEL: 01925 321 888
Known Problems with Cavity Wall Insulation
|Cavity wall insulation was marketed in the early days as a means to saving on heating bills. As a result of this a massive campaign was released by the UK government promoting the benefits of saving energy. Consequently many new specialist companies sprang up all over the place, specifically to sell and install cavity wall insulation. Some of these companies were good, but unfortunately some were not. To understand cavity wall insulation problems we need to look at why buildings are created with a cavity in the first place.|
Basically a cavity between the two walls was thought to act as a barrier against damp. The outer wall would absorb weather and the air in between would prevent any damp moving into the building’s interior. This works fine until you fill that gap with a material that acts as a bridge between the cavity.
In some cases, and in certain areas this has become a serious problem, specially on gable ends that face continuous weather fronts. It is important to understand that the cavity had one job, and that was to keep rain out. It was not until later that newer materials were used on the inner wall to help control temperature.
Since the 80’s it has become a regulation that new homes will be built with insulation pre-installed to help further reduce energy costs. Most of the time this works fairly well as it still allows air to flow between the two walls. The insulation used is normally fibre board which is attached to the inner wall. These fibre boards actually help to prevent damp problems as they are designed to allow water to track down and never touch the inner wall.
Cavity Wall Insulation Problems with Mold and Damp in Older Pre 1980 buildings
Most damp problems were confined to Three mayor things.
- Wall ties that had mortar attached and therefore acted as a bridge between the walls.
- Cavities that have filled at a low level with mortar droppings or building debris.
- In coastal areas sand which has blown in through faulty air vents or roof damage.
All three of these problems could cause damp patches. These problems were easy to put right. It simply requires a few bricks to be removed. Or a simple clean up operation of the effected area of the cavity. Sometimes a wall tie might have been placed at a slightly angled trajectory, and this too could cause some damp or mould patches to appear. By replacing the effected wall ties the fault is still a reasonably simple problem to remedy.
Cavity Wall Insulation Problems in Post 1980’s Buildings
Unfortunately there have been many issues where Cavity Wall Insulation has been miss-sold or not installed correctly. This has lead to wide-scale issues of damp, condensation and Mold and other related issues with the construction of properties.
Many people will be facing far more severe problems in the near future with cavity walls that have been filled with spun fibre. It has been proven that when too densely packed, these fibres actually allow water that has passed through the outer wall to travel across the gap and into the inner wall. This is a serious problem which requires immediate remedial action.
Buildings which are in zone 4 are the ones most subjected to driving rain. Many of these will at some time in the future clearly be the buildings most at risk. In those areas it has been reported that the fibre used as cavity wall insulation acts like blotting paper. The effect of this is that the insulation material retains and traps water that has ingressed into the cavity. Additionally this can be much worse if the fibre has been blown into a cavity which already had debris laying at the bottom.
Most cavity wall Insulation has been fitted as a result of the Government schemes in operation over the past years. If you home falls in to this category the company which did the installation will have issued a guarantee certificate to the home owner. If you are still in possession of this guarantee and it is still in force then we can help you to establish a claim reasonably quickly. However if you can’t find the guarantee, or you believe it may be out of time, then pursuing a claim will take longer but it is still possible. Our team of experts will help with all aspects of any claim for cavity wall extraction.
Do you need Cavity Wall Insulation Extraction?
If you feel you may have problems it is worth checking out now before the problem becomes more severe. You can find out more information below.
We recommend anyone who is living in a house which has retro fitted insulation to have their home inspected by a qualified expert. If you consider that your home is at risk and may need cavity wall insulation extraction then contact us by calling us now on 01925 321 888.
Or simply fill in the NO Obligation inquiry form on our Contact us page by clicking here and our team of expert cavity wall insulation extraction experts will assist you at all stages of the process.